QUICK DATA for QCM 5 MHz 14 mm Ti/Au  (compatible with Q-SENSETM jig)

GENERAL Item Parameter Value 1.0 Sensor design Plano-Plano 2.0 Angle of cut AT 2.1 Frequency vs Temp stability < +/- 5 ppm (0 to + 50 degC) 3.0 Jig compability  Q-SENSETM       ELECTRICAL 4.1 Nominal frequency 5.000 MHz 4.2 Center frequency 4.960 MHz 4.3 Frequency tolerance +/- 10 KHz 4.4 Q-value > 100 000 4.5 Shunt capacitance, C0 Typ. 5 pF       ELECTRODES 5.1 Front electrode diameter 12.0 mm 5.2 Front electrode material Ti/Au,   Titanium / Gold 5.3 Back electrode diameter 5.0 mm 5.4 Back electrode material Ti/Au,   Titanium / Gold 5.5 One sided contacting Yes       MECHANICAL 6.1 Nominal blank diameter 14.0 mm 6.2 Crystal axes orientation Yes 6.3 Surface appearance Transparent 6.4 Bevel Yes

IMPORTANT NOTICE. For the avoidance of any doubt: any and all references to the following trademarks;
Q-SENSE^TM, KSV^TM, INFICON^TM, BALZER^TM, SLOAN^TM, ULVAC^TM, MAXTEK^TM on the Quartz Pro Sweden AB webpage are for customer guidance only and do not purport to constitute or be any part of Quartz Pro Sweden AB´s own trademarks or product designations. The sole purpose of the references made is to establish the fact that the relevant Quartz Pro Sweden AB product is compatible with the product or products manufactured and or distributed under the trademark referenced to. Quartz Pro Sweden AB is an independent supplier and no commercial or legal relations exist between the holders of said trademarks and Quartz Pro Sweden AB.